Sato fuktmåler for næringsmiddel

varenr: 1732-01

Kr. 4500,-

(eks mva)

Kontroller fuktighet med å bruke en elektrisk tester. For å måle mengden vann i et materiale, har som oftest en tørrvektsmetode blitt brukt. Tørrvektsmetoden tar lang tid og en infrarød strålemetode er kostbar. SK-940A utfordrer den tradisjonelle fuktighetsmåler og gjør det mulig med raske og nøyaktige målinger av fuktighet. SK-940A Type 2 leveres med probe egnet for testing av fuktighet i tørket fisk, poteter etc.

Teknisk info

-		Easy. just put the sensor on the object
	-		Quick. complete measuring just by pressing the switch
	-		Accurate. Other than standard range, there are 5 user's ranges available (*Note 1). Average value can also be displayed.
(*Note 1)			user's range is a function which user can define the displayed value of min-max. Increasing or decreasing the displayed value from actual measuring range. You can freely set from low moisture to high moisture.

Measuring method	electric resistance method
Display	3-1/2 digit LCD
Measuring range	9.0% to 40.0% (factory settings)
Measuring temperature	5°C to 40°C (non condensing)
Sensor type	TYPE 1 (length: 3mm x φ2mm, rounded tip) *please refer to the item section for the other types of sensor.
Power requirement	9V 6F22(006P) manganese battery x 1
Functions	Display average value, automatic temperature correction, user's range
Dimensions	Body (W)62x(H)148x(D)24mm
¡¡Weight (Body)	approx. 145g (include battery)

Moisture meter and a sensor is integrated. a sensor is not changeable.

Notes on measuring the object

This moisture meter can't measure materials in a powdery state.
Depending on the pressure which you put the sensor on the object, measured values may vary. Therefore keep apply the same pressure, when you put the sensor on the object.
Temperature correction is done in the main body.

If the temperature is within the measuring range, conversion of measured temperature is not necessary. However if the temperature of measured object is quite differ from the one of moisture meter, SK-940A, there will be error in the measurement. Therefore before the measurement of moisture, please keep temperature of measured object and SK-940A as close as possible.

Note

SK-940A is designed to measure the eletrical resistance between two electrodes and display as relative moisture value. Displayed moisture content is not the absolute value. This moisture meter only display moisture content by using relative electrical resistance value. If the measured object contain electrically-conductive material (such as salts, metal, etc), measured value would differ from actual moisture content. However even If electrically-conductive material is contained in the measured object, if the amount of electrically-conductive material in the measured object is small (small enough so that it does'nt affect much to moisture value) and evenly distributed, it is possible for this moisture meter to measure the moisture value which is used for such as comparative analysis.

Mer om produktet

Tilleggsprodukter

Kalibrering av måleinstrumenter

Vi tilbyr sporbar kalibrering og sertifisering av de fleste av instrumentene vi fører. Vi tilbyr også oversikt over dine instrumenter som skal til årlig kalibrering på portalen www.dinkalibrering.no , en webportal som varsler deg i forkant av sertifikatets utløpsdato, og gir deg tilgang til sertifikatene via portalen.

Ta kontakt

Antall produkter:		0
Sum:		0

Vis handlekurv